Tanning and Sexual Melanotan 2 Information Guide
Melanotan II is a cosmetic sunless tanning product that stimulates melanin production. Melanin is the main determinant of skin color in humans, a brown pigment which causes skin to become darker in appearance, instead of red when exposed to UV rays. Melanotan II users develop a gradual, natural looking tan with minimal exposure to the sun. It is particularly useful for fair-skinned individuals who find that they cannot tan naturally in the sun.
Melanotan 2 peptide is not a treatment or cure for any disease, nor should it be used with the aim of preventing skin cancer. While melanin is known to have excellent photo protective properties, no clinical studies have ever indicated the efficiency of Melanotan II specifically in reducing UV damage.
It is estimated that more than 90% of Melanotan users are familiar with the injectable Melanotan II. Melanotan I is usually only preferred by a small amount of long-term users who feel that Melanotan II makes them too dark, nauseated, and/or those who find the aphrodisiac side effect of Melanotan II to be a nuisance. These problems can be avoided by taking Melanotan II in lower dosages, administering before bed and using sunscreen and clothing to control tanning.
Since Melanotan I has a large body of clinical evidence supporting its safety and efficacy, new users in particular often feel that it would be the better and safer option for usage. Unfortunately this is not the case when it comes to skin darkening and most new users who choose Melanotan I find themselves very disappointed at lack of tanning results since Melanotan I is not intended to be used for this purpose. To achieve similar cosmetic tanning results as seen with Melanotan II, a dose of 10x more per injection is required. Melanotan I is more expensive for tanning.
Melanotan II Storage
In powder (lyophilized) form vials should be stored at refrigerator temperature (2-8 degrees Celsius) where they will remain stable for up to 12 months. Reconstituted (mixed) vials should also be stored in the refrigerator, but use within 8 weeks or they may begin to degrade. They will still be safe to use after this time, but they may not be as effective as new vials.
When to take Melanotan II
The frequency of Melanotan II injections will depend largely on your skin type to begin with, therefore you should identify with which Fitzpatrick skin type you are
Type 1: Pale skin, many freckles, blue/green eyes, red hair, never tans, always burns
Type 2: Fair skin, few freckles, blue/hazel eyes, blonde/sandy hair, tans poorly, usually burns
Type 3: Darker white skin, brown hair/eyes, usually tans, rarely burns
Type 4: Light brown skin, darker brown hair/eyes, tans easily, burns minimally
Loading: Take your Melanotan II dose 1 time per day and continue with daily injections until you are happy with the color of your tan.
Maintenance: To maintain your desired tan, inject your Melanotan II dose just 2-3 times per week Cessation: You can continue the maintenance dosing indefinitely; however, if you choose to stop your Melanotan II injections, your tan will fade back to its pre-Melanotan II shade in 1-2 months.
Assuming the right amount of UV exposure (sun or sun bed) is combined with your Melanotan II usage, then the amount of time it takes to achieve your desired tan (i.e. the loading phase) will usually take 4-8 weeks for skin types 1 and 2 and as little as 2-3 weeks for skin types 3 and 4.
Melanotan II and UV Exposure
The tanning activity of Melanotan II without the need for UV exposure has been proven by clinical trial; however, the majority of users report that results are achieved much quicker, and that the tan is a more natural color, when Melanotan II is combined with a small amount of UV exposure.
Tanning should start after the third injection and occur 2-3 times per week if you wish to see tanning results quickly; otherwise one tanning session per week is sufficient to gradually build your tan
If you are not seeing results then you need to increase the frequency of your outdoor or indoor UV exposure (especially if you are skin types 1 or 2). Never increase your recommended Melanotan II dose.
Tanning sessions should be short, 5-10 minutes in a sun bed or 30-40 minutes in the sun on a warm day is sufficient each time. DO NOT overexpose yourself to UV rays.
When starting out always use 30+ sunscreen on sensitive areas such as the face and neck. Because these areas are frequently exposed to UV rays they are more responsive to the melanin producing effects of Melanotan II and therefore will become darker quicker than the rest of the body. Covering these areas initially will allow other parts of the body to tan first, ensuring you achieve a well balanced tan.
Melanotan II and UV exposure complement each other, so if you spend a lot of time tanning you will need less frequent injections of Melanotan II to obtain and maintain your tan. If you don't spend much time in the sun or sun beds then you will need frequent dosages of Melanotan II to develop and keep your tan ..
Fair skinned folks who never tan, always burn in the sun, can achieve a natural tan when using Melanotan 2. For people with sun allergies these discoveries are life changing. The best defense against skin cancer is a natural tan developed over time. MT-2 was designed to reduce skin cancer rates and be effective as a sunless tanner.
Athletes and fitness enthusiasts use Melanotan for sunless tanning, Libido increase and and appetite suppression. MT-2 was dubbed the Barbie drug and has been highlighted in wired magazine. Synthetic melanocortin use helps attain a tan with the least amount of exposure to harmful ultraviolet radiation.
Fitzpatrick skin type: Skin type I and II, the lower of the skin types on the Fitzpatrick scale are the best candidates for Melanotan 2 who see the most dramatic results.
Treatment: Melanotan stimulates melanin effectively, in particular those with low skin types.
Shipping and Handling: Melanotan Peptides are durable and stable. Highlighted in study, the reconstituted MT-2 was shown to be stable at 37 degrees Celsius (98 degrees Fahrenheit) for at least 28 days. Shipping MT-2, even in summer months, is not a problem. Do not pay for cold shipping as it is not a premium. When receiving MT-2 it is recommended to store in the refrigerator.
Mixing: Add BW to the vial when you are ready to begin MT-2 research.
Remove plastic flip top from vial to expose rubber stopper. needle will pierce the stopper making way inside the vial to turn the white ****** into a clear liquid.
Calculator: Add 100 units (1ml) of water to the vial. 1ml/100 units will minimize the volume that you have to inject and will simplify the arithmetic in your MT-2 experiment. Dosing measurements are often mentioned in both milligram (mg) and microgram (mcg). Example: .5mg = 500mcg
1ml syringe (U100), 1ml BW to reconstitute
Calculations for a desired 0.5mg dose:
Step 1= 1ml
Step 2= 10mg MT-II
Step 3= 1ml bac water
Step 4= 500mcg dose
2-3 ticks on your insulin pin (approximately 1/20th of a U100 syringe)
Some prefer to add more diluent which works fine, take note of the volume increase.
Needles: 29-31 gauge X 1/2", 1 CC (100 unit). That is a typical insulin needle used to mix as well as inject. Use needles one time only. Once your technique perfected, injections are almost painless.
Starting dose: Your first injection should be a very small dose, for example .25mg (250mcg). See how you react. Goal should be to feel nothing. Dose after dinner, before bed. Any dosing chart stating that you should take a high dose (according to your weight) is outdated and potentially dangerous.
Loading dose: Load with 0.5-1mg once a day. People who have used doses in this range generally report getting excellent results. Don’t worry if you miss occasional days. It will not make much difference, focus on the cumulative effects.
Maintenance dose: Maintenance is taking doses less frequently than daily to avoid becoming darker than you want. Yes, that will happen. With enough UVR, you will get much darker than you have even been before. A maintenance dose can help prolong super-physiological photo-protection MT-2 delivers.
UV Radiation: Melanotan is a poor sunless tanner. UV (from sun or a tanning bed) light is necessary to develop a tan. Without it, almost nothing happens. In other words, NO UV = NO TAN. Well, user will pigment depending on skin type.... If you have loaded for a full month and then start UV exposure, you (and your friends) will be astounded by how fast you tan and how dark you get. Moreover, it is advisable to keep areas of your skin that ordinarily get exposure covered up with a towel and/or zinc oxide (nose/lips/face) and let less exposed areas develop pigmentation first. Areas of skin that are typically sun-exposed in your day to day life will respond more readily to the effects of the Melanotan Peptides.
Fat Loss: The melanocortin (MC) system is a signaling pathway for leptin and insulin. The MC system is important for control of food intake and body weight. MT-2 treatment results in adipocyte lipolysis. MT-2 increases fatty acid oxidation(FAO) in which the MC5R plays a significant role. MT-2 improves insulin sensitivity through stimulating FAO in skeletal muscle tissue. Reduced food intake from the anorectic response of MT-2 is primarily responsible for weight loss.
Watch yourself: Your tan can sneak up on you. A tan generally sets in 3 days after UV rays. Dose and expose yourself gradually to UVR when tanning. Love your skin.
Avoid burning: You are protected from burning mostly by your tan, not the MT-2 peptide. Therefore, don’t overdo the rays at first. Start with only as much UV that you could tolerate without burring before you began Melanotan. It should not take many weeks before you can tolerate hours of strong sun without burning. Truly incredible for those who have never experienced freedom to enjoy the sun.
Continue your regular dosing protocol until you have reached your desired tan and do not want to become darker. Cut injection frequency to once every 2, 3, 4, or even 7 days. Experiment to find the frequency that gives the tan you want.
Storage: Store freeze dried and reconstituted (mixed) Peptides in the refrigerator.
Do you have to inject MT-II?
Yes. The best, most efficient method of administering Melanotan Peptides are subcutaneous (subq) injections. Nasal sprays are inconsistent and inefficient. No detectable levels were observed following oral dosing - pills do not work.
when you start supplementing (Melanotan II) to tan keep in mind that tanning is literally a side effect. The tanning response is, in reality, a physiological repair mechanism to instant UV damage of the skin cells (. Melanocyte stimulating hormone is not going to color your skin, it is going to make your own skin create its own tan and that in turn creates protection. If you are looking to be some bronzed beach God with perfectly uniform and specific color then you are better off to going to mystic tan. Redheads, for example, naturally produce a variant form of melanin that is yellowish-red . Do not expect a brown tan on a ginger body right away.
Know your skin type: Knowing your skin type is just one detail which will help create a public user log. There are 10s of thousands of Melanotan users worldwide who share the experience. Raise awareness and help others who want to hear success stories, complications and failures.
Am I a good candidate for MT-II?
Melanotan is best suited for the folks with skin types I & II. Prior sun damage, scars, tattoos, freckles, moles, hair color, etc are deciding factors prospective MT-2 users consider.
How should I dose MT-II?
Melanotan II dosage it is recommended to start out small and build up. A typical starting dose is around .25mg and max dose reaching 1mg. Desensitization happens quick, the first administration is an opportunity to dose low to avoid Melanotan 2 side effects. Same goes for Bremelanotide (PT-141) dosage unfortunately.
Melanotan Instructions: There is no magic pill or formula. Instructions do not exist for research Peptides. Few dermatologists are familiar with Melanotan. The skin is a large, unpredictable organ. Feel comfortable and confident with MT-II before use. Check out as many before and after photos and user logs as you can. A skin type I individual may have to commit months of dedication before dialing in their desired results, be patient and ask questions.
How much MT-II should I buy and how long will it last?
Skin type I: 30-50mg
Skin type II: 20-30mg
Skin type III: 10mg
Should last entire summer or season
How soon will I begin to see results from Melanotan II?
You should notice a change in your skin tone after three weeks. If you have freckles, expect them to get darker before your actual skin color changes.
How long will the tan last?
A tan developed using Melanotan 2 lasts much longer than an ordinary tan. A well-tanned person returning from a beach holiday will lose most of the tan in a month if they stop getting sun. But if they had been using Melanotan 2 and continued on maintenance after returning, they would still have most of their tan 3 months later.